Arduino Lcd Display Spi Tft 2.2inc 320x240 Arduino Raspberry

MODULO LCD DISPLAY TFT DE 2.2" 320 X 240 SD-SLOT- INTERFASE SPI - CONTROLADOR ILI9341 DE 18 BIT 262K COLORES -- SOLO REQUIERE 4 PINES DEL ARDUINO O MICROCONTROLADOR -
- IDEAL ARDUINO NUCLEO ARM RASPBERRY PIC AVR ROBOTICA -


Description:


This lovely little display breakout is the best way to add a small, colorful and bright display to any project. Since the display uses 4-wire SPI to communicate and has its own pixel-addressable frame buffer, it can be used with every kind of microcontroller. Even a very small one with low memory and few pins available!

The 2.2" display has 320x240 color pixels. Unlike the low cost "Nokia 6110" and similar LCD displays, which are CSTN type and thus have poor color and slow refresh, this display is a true TFT! The TFT driver (ILI9341) can display full 18-bit color (262,144 shades!). And the LCD will always come with the same driver chip so there's no worries that your code will not work from one to the other.

The breakout has the TFT display soldered on (it uses a delicate flex-circuit connector) as well as a ultra-low-dropout 3.3V regulator and. We also had a little space so we placed a SD card holder so you can easily load full color bitmaps from a FAT16/FAT32 formatted SD card.


Features:


Controller ILI9341
Logic Level 3.3V
2.2" diagonal LCD TFT display
QVGA 320x240 resolution, up to 18-bit (262,144) color
ILI9341 controller with built in pixel-addressable video RAM buffer
4 wire SPI digital interface
Built-in SD slot - uses 2 more digital lines
Onboard 3.3V 150mA LDO regulator
4 white LED backlight, transistor connected so you can PWM dim the backlight
0.1" spaced header for easy breadboarding
Module Size: 67mm(length) x 40mm(width) x 4mm(thickness)
Active Area: 47.5mm(Length) x 36.5mm(Width)
Current draw is based mostly on the backlight: with full on backlight, current draw is approx 100mA


Schematic:



Pinout:


SDO (MISO): Serial clock output
LED: 3.4V Power Supply pin
SCK: Serial clock input
SDI (MOSI): Serial data input
D/C: Data / Command selection
RESET: Reset, Low level active
CS: Chip Selection, Low level active
GND: Ground
VDD: 3.3V Power Supply pin 


Size: